# Cockpit coaming - wood duck 10

**URL:** <https://forum.clcboats.com/t/cockpit-coaming-wood-duck-10/33910>\
**Category:** Builder's Forum\
**Created:** [April 17, 2008, 11:08am UTC](https://forum.clcboats.com/t/cockpit-coaming-wood-duck-10/33910 "2008-04-17T11:08:38Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Laurie\_Olson](https://avatars.discourse-cdn.com/v4/letter/l/e99b99/32.png) [@Laurie\_Olson](https://forum.clcboats.com/u/Laurie_Olson)\
**Post date:** [April 17, 2008, 11:08am UTC](https://forum.clcboats.com/t/cockpit-coaming-wood-duck-10/33910/1 "2008-04-17T11:08:38Z")

</div>

&nbsp;

The manual seems to recommend coating all parts (spacers and coaming) with glue and clamping all the pieces to the deck at once.&nbsp; Given that the spacers are cut in half, getting all of these sandwiched pieces to line up at once feels cumbersone and difficult.

Would it be better to glue each&nbsp;layer to the deck separately letting it dry before adding the next piece of the sandwich?

Thanks

---

<div class="post-metadata">

**Author:** ![Ralph\_Lambert](https://avatars.discourse-cdn.com/v4/letter/r/8797f3/32.png) [@Ralph\_Lambert](https://forum.clcboats.com/u/Ralph_Lambert)\
**Post date:** [April 17, 2008, 11:26am UTC](https://forum.clcboats.com/t/cockpit-coaming-wood-duck-10/33910/2 "2008-04-17T11:26:37Z")

</div>

For my WD12 I attached my coaming in sequential sessions, not all at once.

---

<div class="post-metadata">

**Author:** ![Laszlo\_Morocz](https://avatars.discourse-cdn.com/v4/letter/l/c68b51/32.png) [@Laszlo\_Morocz](https://forum.clcboats.com/u/Laszlo_Morocz)\
**Post date:** [April 17, 2008, 11:54am UTC](https://forum.clcboats.com/t/cockpit-coaming-wood-duck-10/33910/3 "2008-04-17T11:54:05Z")

</div>

For my 12 not only did I do it sequentially like Ralph, I also put a layer of plastic between the deck & bottom spacers. Once the layers cured, I was able to lift off the entire coaming assembly and sand underneath the rim.

Laszlo