# millcreek 16

**URL:** <https://forum.clcboats.com/t/millcreek-16/40321>\
**Category:** Builder's Forum\
**Created:** [November 22, 2012, 11:24am UTC](https://forum.clcboats.com/t/millcreek-16/40321 "2012-11-22T11:24:15Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![tlar](https://avatars.discourse-cdn.com/v4/letter/t/c6cbf5/32.png) [@tlar](https://forum.clcboats.com/u/tlar)\
**Post date:** [November 22, 2012, 11:24am UTC](https://forum.clcboats.com/t/millcreek-16/40321/1 "2012-11-22T11:24:15Z")

</div>

Just cut out the sheer panels on this boat. However I messed up on one of the scarfs in that the carf was sanded too thin amd broke away leaving a small deppression on the panel. What is the easiest/best method of filling the depression so I wont see the repair on the finished painted hull?

thanks

---

<div class="post-metadata">

**Author:** ![Keith\_Powell](https://avatars.discourse-cdn.com/v4/letter/k/7ba0ec/32.png) [@Keith\_Powell](https://forum.clcboats.com/u/Keith_Powell)\
**Post date:** [November 25, 2012, 2:29pm UTC](https://forum.clcboats.com/t/millcreek-16/40321/2 "2012-11-25T14:29:44Z")

</div>

Could you get some thickened epoxy in there? It will fill the void and tie it all together. If anything is above the surface when it cures, use a scraper instead of sanding... or at least minimize sanding. Seeing as how you will be painting, it will be invisible when it's all done.

Keith