# Oxford Shell II finished dimensions

**URL:** <https://forum.clcboats.com/t/oxford-shell-ii-finished-dimensions/49048>\
**Category:** Builder's Forum\
**Created:** [September 30, 2021, 2:27pm UTC](https://forum.clcboats.com/t/oxford-shell-ii-finished-dimensions/49048 "2021-09-30T14:27:20Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Clarence\_Guthrie](https://avatars.discourse-cdn.com/v4/letter/c/67e7ee/32.png) [@Clarence\_Guthrie](https://forum.clcboats.com/u/Clarence_Guthrie)\
**Post date:** [September 30, 2021, 2:27pm UTC](https://forum.clcboats.com/t/oxford-shell-ii-finished-dimensions/49048/1 "2021-09-30T14:27:20Z")

</div>

Greetings! First post.

I have always wanted a sliding seat rowing shell, and I am almost about to pull the trigger on an Oxford Shell II kit. The only place I can build it, however, is my climate-controlled basement, which means it would need to pass though a 20" by 50" window. I found the finished length and width dimensions, but cannot find the height anywhere.

Can anyone provide the finished height dimensions from bottom of hull (keel, I guess?) to top of deck (coaming?) at thickest part? If it is too thick it could be a dealbreaker.

Thanks much,

---

<div class="post-metadata">

**Author:** ![George\_Krewson](https://avatars.discourse-cdn.com/v4/letter/g/9d8465/32.png) [@George\_Krewson](https://forum.clcboats.com/u/George_Krewson)\
**Post date:** [October 2, 2021, 7:45am UTC](https://forum.clcboats.com/t/oxford-shell-ii-finished-dimensions/49048/2 "2021-10-02T07:45:26Z")

</div>

&nbsp; &nbsp;Go to the Oxford II page and scroll clear to the bottom, there's a guide to what size hole you'll need to get it out of the basement. You'll find your window is plenty big!

George K

---

<div class="post-metadata">

**Author:** ![Clarence\_Guthrie](https://avatars.discourse-cdn.com/v4/letter/c/67e7ee/32.png) [@Clarence\_Guthrie](https://forum.clcboats.com/u/Clarence_Guthrie)\
**Post date:** [October 4, 2021, 10:56am UTC](https://forum.clcboats.com/t/oxford-shell-ii-finished-dimensions/49048/3 "2021-10-04T10:56:30Z")

</div>

Thank you George K! I did not scroll down far enough to see it and completely missed it. Shows how much attention to detail I lack.

Thanks much,