# Sanding and bottom edges on kaholo **URL:** \ **Category:** Builder's Forum\ **Created:** [July 29, 2016, 2:32pm UTC](https://forum.clcboats.com/t/sanding-and-bottom-edges-on-kaholo/44430 "2016-07-29T14:32:11Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![Jan\_Rodriguez](https://avatars.discourse-cdn.com/v4/letter/j/f05b48/32.png) [@Jan\_Rodriguez](https://forum.clcboats.com/u/Jan_Rodriguez)\ **Post date:** [July 29, 2016, 2:32pm UTC](https://forum.clcboats.com/t/sanding-and-bottom-edges-on-kaholo/44430/1 "2016-07-29T14:32:11Z")
So this is my first wood working project. The book doesn’t quite explain how far to sand the hull edges or chines if I’m supposed to see a little of the fillets or rounded enough and fill in the channel between the two edges of plywood (so far I don’t see any gaps. ). Thanks for any advise! ---
**Author:** ![George\_And\_Judy\_Mart](https://avatars.discourse-cdn.com/v4/letter/g/73ab20/32.png) [@George\_And\_Judy\_Mart](https://forum.clcboats.com/u/George_And_Judy_Mart)\ **Post date:** [August 1, 2016, 10:51am UTC](https://forum.clcboats.com/t/sanding-and-bottom-edges-on-kaholo/44430/2 "2016-08-01T10:51:03Z")
   I just checked out the construction photos of a kaholo and was pretty surprised at the complexity. Not just a board you stand on at all. If I understand your question,the edges should be rounded to give a nice smooth curve. If you get to the fillet underneath, youve gone too far. ---
**Author:** ![Jan\_Rodriguez](https://avatars.discourse-cdn.com/v4/letter/j/f05b48/32.png) [@Jan\_Rodriguez](https://forum.clcboats.com/u/Jan_Rodriguez)\ **Post date:** [August 1, 2016, 12:20pm UTC](https://forum.clcboats.com/t/sanding-and-bottom-edges-on-kaholo/44430/3 "2016-08-01T12:20:38Z")
that’s what I would think. Just enough to where the FG can be smoothed over the edge