Hello All! Hope you all had a great Holiday!
I'm out of 4mm for my hatch covers on my 17lt. I do have some 6mm left over from my coaming components. Do you think it would be fine to use the 6mm for my hatch covers? I guess they would just sit 2mm higher than the 4mm. I would hate to have to order a full or half sheet just for this. Thanks, Justin
I used 3mm for the deck. The forward hatch was pretty tough to get the right shape. I ended up using 3 formers. 6mm would be pretty tough to work with for the front. The back might work out well?
Bending might an issue. Could you not plane the 6mm down? Have you considered stripped Hatches?
Thanks for the input guys! I guess I could sand the 6mm down a couple mm. Never thought of that!! Love this forum!