I messed up on the bolt setup for the 2 bulkheads on the Eastport Nesting pram and am in need of advice on how to correct.
When I installed the bolts, I failed to sandwich the two bulkheads together. I just epoxied the bolts into the one bulkhead. Surprisingly, all but 2 bolts match up – those 2 are not square to the frame and are about 1/8 inch out of alignment with the holes. I’ve thought up a few solutions –
1. Pound the 2 bolts out and start again. I’m not sure if this will work or if it will result in tearing out a lot of wood around the bolt hole. Opinions?
2. Re-drill the holes in the second bulkhead and/or bend the bolts to correct alignment. I’m thinking to use a straw over the bolt when I do the epoxy – that should give me a good aligned hole.
Any other suggestions?