I'm just about done with my shearwater sport sectional, and I'm seeing that there are places on the bulkheads that don't have epoxy on them. Did I miss a step along the way? I'm assuming I should give them a coating to keep them dry. (This is the side facing the cockpit and the hatches -- the sides where they connect were epoxied when I added fiberglass.)
There should be no bare wood anywhere.This is to prevent or at least slow down moisture intrution as much as posible. Two coats at least is preferable.
   I was wondering if it was a good idea to epoxy the inside surfaces of the oar before assembling it. Imbuilding the peeler I figure I could eliminate a lot of sanding if I epoxies on a flat surface instead of a vertical surface after assembly. Any thoughts on the. Subject ?