I’ve had my Lake Union Swift out for just a few sails after completing it last month, and now, sadly, it’s time to put it away until spring.
While I have a fair amount of sailing experience, it’s all been on Bermuda rigged sloops or windsurfers. So far I’m liking the balanced lug (62 sq ft, same sail and spars as the Skerry, Passagemaker, Tenderly, and NE Dory), but I’ve got a lot to learn about how to best optimize it under different sailing conditions.
I’ve got the halyard and downhaul attachments at the points shown on the plans, and I’ve got a 3:1 purchase on the downhaul, having read about the importance of sufficient tension there. My mainsheet also follows the plans with a becket block on the boom near the clew, and the mainsheet starting at the becket, going down to block on a transom-mounted bridle line, back up to the aft boom block, and forward to a second block on the boom about halfway to the mast.
So far, so good, with the only concern being that when winds are maybe in the 12-14 knot range (the most I’ve seen so far), I’m getting a good bit of leach flutter going upwind. This breeze wasn’t sustained enough for me to try any tweaks other than downhaul tension, but I couldn’t get rid of it just with that, and cranking down pretty hard. I have not yet sailed with a reef in.
Any suggestions for how to tame it? I’ve had leach lines on bigger boats, but don’t want to go that route here. Wondering if moving the downhaul aft some might help? Maybe tighter lashing/outhauls on the spars? Could too much downhaul be a factor?
This isn’t a huge concern for me, and if were out in any more wind I would want to reef, and maybe that’s the solution right there?
Thanks for any insights.