Oxford Shell II finished dimensions

Builder's Forum
1

Greetings! First post.

I have always wanted a sliding seat rowing shell, and I am almost about to pull the trigger on an Oxford Shell II kit. The only place I can build it, however, is my climate-controlled basement, which means it would need to pass though a 20" by 50" window. I found the finished length and width dimensions, but cannot find the height anywhere.

Can anyone provide the finished height dimensions from bottom of hull (keel, I guess?) to top of deck (coaming?) at thickest part? If it is too thick it could be a dealbreaker.

Thanks much,

2

   Go to the Oxford II page and scroll clear to the bottom, there's a guide to what size hole you'll need to get it out of the basement. You'll find your window is plenty big!

George K

3

Thank you George K! I did not scroll down far enough to see it and completely missed it. Shows how much attention to detail I lack.

Thanks much,