Skerry - aft seat fit - strange "stepped" pattern

Builder's Forum
1

I'm dry fitting the seats in my Skerry and they all seem to fit very well as cut by the factory, with no modifications needed.  Except the aft seat which has a strange "step in" cut into the last 8 inches or so on each site that causes a 1/2-inch gap between the seat and the hull.  It seems that it would fit perfectly without this "step."  Am I misunderstanding something or do I just need to create an enormous fillet here?


https://www.amazon.com/photos/shared/er0ZRRmBSEukGOztloRQuQ.UV9gusuFiTosHdcuFfUkVM

2

   Good question.  I'm trying to remember running into such gap when I'd installed the aft deck and have no memory of it - thought that doesn't mean it wasn't there.  

3

I remember there being a gap there that got filled with large fillets. I have no idea if there's a better way to do it.  Might be able to shave down the slots the bulkheads fit into if the tip isn't touching the fillets behind it.