Deck to hull transition

I am preparing to fiberglass the deck. When I glued the deck I ended up with lots of drips particularly in the fore section. I did turn the boat upside down but the drips remained. I know I will need to sand the hull down before painting the hull. I have used a scraper to shave the drips down.



My question is do I need to sand smooth the top of the hull section where the fiberglass will overlap onto the hull? I have rounded over the deck/hull intersection.

Hi Robert,

I would sand it smooth even though you are still going to overlap with cloth and end up sanding again.

The main reason is that if you glass over an unsmooth surface, you will get an unsmooth surface and you are just moving the work to the ultimate smoothing.

But you also get a less consistent/efficient glassing becuase if you lay glass over an unsmooth surface you will either sand through the glass where it bulges over the bumps or gain a lot of epoxy weight filling in the low spots.

H

Howard,

Will do. Thanks again.

Rob

No more drips. Ready for fiberglassing.

Looks really good.

fwiw, i usually take the foot brackets off for sanding and painting and then screw them back in. its a hassle to do it and not a requirment, but i find it made it easier to paint and sand.

h

Howard,

Great idea. It was awkward sanding around them. I damaged one of them by drilling through the plastic threads. One of the screws is barely holding anything.I might have to replace them anyway.

Rob

Howard,

oh, and I used 100 grit as you have suggested in the past.

Rob