I'm just to the point on my Eastport Pram plans builD to create and install the daggerboard trunk. But as near as I can tell nowhere in the plans does it describe the dimensions of the spacers for the trunk. Eyeballing the directions I can get a rough sense. But obviously the width and exact dimensions seem pretty critical given where it is, etc.
I feel like it must be somewhere in the plans. How could it not be? But I've looked all through the lofting blueprints and the manual. And I cannot find it anywhere. I'm wondering if it's just assuming that it's obvious. But again, seems like a pretty critical place to get your dimensions right since you're talking about a hole in the hull.
Does anyone know or has anyone run into this issue and can advise? Thanks in advance for any assistance!
JOSH